Hello Guest it is February 29, 2020, 07:45:59 AM

Author Topic: Mach 3  (Read 1309 times)

0 Members and 1 Guest are viewing this topic.

Mach 3
« on: December 08, 2012, 04:14:59 AM »
I have a CNC desktop engraver.(Chinese)
Running it on a desktop with Win XP, no other software on computer.
Running Mach3 software.
Page up sends the spindle down, page down sends the spindle up.
Machine leaves an underscore across the plate being engraved.
Can anyone offer any advice about possible causes?
Any assistance would be gratefully accepted.
Newbie from Brisbane

Offline Tweakie.CNC

  • *
  •  8,157 8,157
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Mach 3
« Reply #1 on: December 08, 2012, 04:25:32 AM »
Within Mach3 - Config / Ports and Pins / Motor Outputs - change the 'Dir Low Active' state for your Z axis (this reverses the direction of the stepper motor).

Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.