Never had much luck with Run From Here, but I thought I give it another shot. If I stop the program, roll it back to a previous line number and hit Run From Here, it is supposed to prompt for a prep move, then after moving a second cycle start press restarts the program. This only works if I have the Z axis inhibited. Other wise when Mach does it's simulation run to determine the prep move, it hangs on M03...which is the code to fire the torch.
The line before that is also an M code that does a G31. Is mach trying to simulate the G31 inside that M code? There is some code there that tells it not to run the G31 if Z is inhibited. If so, is there a way to tell it to ignore M codes during a RFH simulation run? I have "Ignore M codes on loading" checked in general config.
Thanks