To Tweakie. Thanks for your feed back. I was hoping a laptop would work but I don't have a clue what a external motion controller is.
Anyways about the question on the limit switches. I finally figured out what was wrong last night. I plug my router cable and printer cable into a A/B switch and I started to get out my multimeter and do some checking on my router cable and noticed the plug didn't look like it was seated all the way. Sure enough, it was not. It started working OK, well sort of OK. I could jog but it kept tripping out "limit switch made". No, it was not so I started checking and found that one micro witch connector is loose inside. I went to the diagnostic tab and could see by wiggling the connector I could trigger the LED very easily So now I will have to replace that switch. Like I said, I only had normally open micro switches so I made a plate, mounted the 2 micro switches backwards and put in push rods with small tabs on the one end and spring loaded the push rods so the tabs will compress the micro switch button. Not that I am cheap but like to do with what I have on hand and not run to the store. I do a lot of McGiver stuff.
No clue to what I will do with the router table, probably just make lots of wood dust and chips. I am just enjoying building the table. It is pretty small, like 12" on the Y and 20" on the X travel. Just something to play around with and occupy my time and brain. Being retired can get to you if you don't do something other than sit around.