Hello Guest it is November 16, 2019, 07:50:36 PM

Author Topic: adding extra breakout board  (Read 1163 times)

0 Members and 1 Guest are viewing this topic.

adding extra breakout board
« on: September 29, 2012, 07:07:58 PM »
Hello I am using a 3 axis cnc that was build by someone else, And I am hoping to add a lathe and tangential cutter. I dont need to use them both at the same time should I get two drivers and steppers or just one and switch them somehow?

I am currently using a c11 board from cnc4pc.com with 4 steppers and gecko drivers.