Hello Guest it is December 14, 2024, 04:45:28 AM

Author Topic: Problem configuring plasma table  (Read 2563 times)

0 Members and 1 Guest are viewing this topic.

Problem configuring plasma table
« on: September 18, 2012, 12:33:03 PM »
Hi,

       Not sure what I am doing wrong. I have Mach3 running to a plasma table and in Mill configuration, everything seems to work and I get proper movement. When I try to use the Plasma configuration the motors do not respond correctly to the hot keys. Anyone else have this problem?

Thanks

Steve
Re: Problem configuring plasma table
« Reply #1 on: September 18, 2012, 07:07:04 PM »
OK  FOUND the problem.
Under  Config>Ports and pins >port setup and axis selection  Max NC node had Max CL Node checked and that caused the motor outputs to go weird.
After I unchecked it everything works great!

Steve