I use my limitswitch as a home switch and I need to home off from the switches a few mm as to not trip them accidentally.
I have two problem with this:
1: If I set the softlimits to 2mm, I always have to turn them off when Mach3 starts because the machine is out of limits (x0y0z0) and then turn them on after, which is easy to forget.
2: Even if the Z axis is set to home off to -2mm, is doesnt, it only sets the dro to 2mm and if I jog it upwards it trips the switch at -1.9mm, so for this axis I have to set the soflimits a few mm down and then jog there after I reference the axis?