Hello Guest it is July 17, 2019, 01:12:19 PM

Author Topic: mach 3 probs  (Read 1245 times)

0 Members and 1 Guest are viewing this topic.

mach 3 probs
« on: September 03, 2012, 07:20:31 PM »
ok i am getting my plasma table going , when i use jog keys they only run one way! on the screen it shows the numbers changing both ways but motors only go one way

Offline Tweakie.CNC

*
  • *
  •  7,844 7,844
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: mach 3 probs
« Reply #1 on: September 04, 2012, 01:34:40 AM »
Hi Roman,

First thing to check is that you have the Direction pin configured correctly in Config / Ports and Pins / Motor Outputs.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.