Hi Hood,
Hoping you could help me with a little problem I am having with a bit of code I wrote. Up to now I have not bothered with the switching of Output #7 as I have only wired it in today. The code I did was to set the output #7, wait for input #1, reset output #7, then move 60 degrees at a feedrate of 10000, and call it Macro M211. When I have been running the program, it runs fine and waits for input #1. Now that I have the output #7 configured (port 2 pin 1) and wired, I don't see it turning on and off. If I go into my Ports and Pins Output config, I can set it by making it low active, so I know it is configured and wired OK.
My M211 Macro looks like this:
ActivateSignal (OUTPUT7)
SystemWaitFor (INPUT1)
DeactivateSignal (OUTPUT7)
Code "G91G1A60F10000"
My program code is:
M211
G4P2
M211
G4P2
M211
G4P2
M211
G4P2
M211
G4P2
M211
G4P2
M30
This rotates my fixture a total of 360 degrees (6 x 60 degrees)
Thanks, Barry.