Hello Guest it is May 07, 2021, 10:21:26 PM

Author Topic: Large circles in g-code...  (Read 1955 times)

0 Members and 1 Guest are viewing this topic.

Large circles in g-code...
« on: August 04, 2012, 08:04:14 PM »
hello everyone,

Well I'm back with another problem...

I posted g-code using a trial version of Vectric Cut3D using a sample file supplied with the software that was supposed to allow you to save the tool path to g-code.  When I load the g-code file using Mach3 several large (magenta) circles appeared in the g-code preview window.   looked like these large circle were actually short circular segments between points A and B that went around in the opposite direction from point B to point A.

What do you think?  Does anyone know what caused them?


Offline ger21

  • *
  •  6,289 6,289
    • View Profile
    • The CNC Woodworker
Re: Large circles in g-code...
« Reply #1 on: August 04, 2012, 08:29:50 PM »
Change your IJ mode to incremental

2010 Screenset

JointCAM Dovetail and Box Joint software
Re: Large circles in g-code...
« Reply #2 on: August 04, 2012, 11:40:43 PM »

Thanks Gerry..!!  This fixed it..!!