Wondering if someone could take a look at another Opto Sensor type. It's the
HOA1405-001. It doesn't require a slot because the IR LED and the Sensor are pointed at an angle to each other so all that's needed is a reflective spot.
I'm just to ignorant to make a definitive call on how the wires go together.
I'm using the cnc4pc c11 board.
My thoughts were as follows but it didn't work.
C - Input Pin on BOB
E & K - Wired together and put on GND of BOB
A - Place 220 Ohm resister prior to connecting to 5V on BOB.Any advice would be appreciated before I destroy something. I don't want to fry the IR LED nor burn out the Sensor. Also want to make sure I put the Ground wire where it's supposed to go on the c11 as well.
I have been trying to get the c11 board to recognize a signal from both the opto-sensor as well as a magnetic sensor for spindle speed.
I have tried multiple wiring configurations, but only if I thought they were safe and no danger of messing up the c11 board.
I have set Mach in various permutations of debounce numbers, active low, enabled, etc. for both the Input settings and the Spindle setup tab.
I've tried with and without a 4.7K Ohm resistor across the 5V and the Pin 13 wire (just like my probing setup) but can't even get the LED to light up on either Pin 12 or Pin 13 no matter what I do.
Any help would be appreciated.
I just opened a Work Ticket with cnc4PC a few minutes ago so understandably I haven't heard anything back yet.
Thanks,
Vogavt