Hi,


I am very new to the machine and i'm so confused on how you set your own limits on the table and how to set it so each time I "REF ALL HOME" it will go back to zeroing out my mach3 machine. ALSO i'm having a hard time understanding the difference between:

-how the soft min/max sets the limits for my mach3
-setting the correct display mode/scale for my tool path
-how to set up my machine coordinates (I don't have my limit switches hooked up yet either, so i'm not sure if its possible to set up the coordinates without them)

and also my Tool path does not show the design of my Gcode on display.

Any advice? Again, I am very new to this machine, and have no idea where to start, feeling hopeless.... hoping i'll understand it all very soon though.

V

Answered in your other post.
Hood