Hello Guest it is July 11, 2020, 04:16:00 PM

Author Topic: HOMING TROUBLE  (Read 1628 times)

0 Members and 1 Guest are viewing this topic.

HOMING TROUBLE
« on: June 22, 2012, 12:29:37 PM »
 Hi,


I am very new to the machine and i'm so confused on how you set your own limits on the table and how to set it so each time I "REF ALL HOME" it will go back to zeroing out my mach3 machine. ALSO i'm having a hard time understanding the difference between:

-how the soft min/max sets the limits for my mach3
-setting the correct display mode/scale for my tool path
-how to set up my machine coordinates (I don't have my limit switches hooked up yet either, so i'm not sure if its possible to set up the coordinates without them)

and also my Tool path does not show the design of my Gcode on display.

Any advice? Again, I am very new to this machine, and have no idea where to start, feeling hopeless.... hoping i'll understand it all very soon though.

V

Offline Hood

*
  •  25,846 25,846
  • Carnoustie, Scotland
    • View Profile
Re: HOMING TROUBLE
« Reply #1 on: June 23, 2012, 02:16:04 PM »
Answered in your other post.
Hood