Hello Guest it is February 03, 2023, 09:05:44 PM

Author Topic: VB for exporting G code and commands to twincat  (Read 2204 times)

0 Members and 1 Guest are viewing this topic.

VB for exporting G code and commands to twincat
« on: June 10, 2012, 05:54:00 AM »
I have an twincat NC controller. It accepts G code. Are the following things possible

-sending actual G code command
-returning actual positions from twincat to mach3
-getting the jog commands, set zero commands from mach3

I have knowlegde to get those thing in twincat (by use of ads twincat protocol) but i lack knowledge of mach3 to know if it is posible

thanks a lot
Pieter Devlies