Third party software and hardware support forums. > NC Pod
Welcome To The NC Pod Development, Discussion and Support Topic
Amnz:
I don't know for sure if this is what the ncpod looks like, but you can remove it if it's incorrect
Greolt:
Yeah that's what it looks like. After all that is the photo from the manufacturers site. :)
Great to see a forum for the ncPod at last.
dacostad:
How would you connect the pod to say a Xylotex controller car?
Thanks
David
Greolt:
It looks to me like you would need to make a rather complicated cable or a adapter / break out board.
I think you will find the next version will allow for more connection types.
Also I did hear that CandCNC is planning addon boards for it. Others will probably do the same as it becomes popular.
http://www.cnczone.com/forums/showpost.php?p=236619&postcount=18
rcrabb:
Just got my NCpod. I followed all the instructions, Installed the firmware, but I just can't seem to get it to stay comunicating with Mach. Can anyone help me ???
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version