Hi Guys,
I have a new NC Pod control box hooked up to my four servos (X, Y, Z, A) on my Sherline mill. Most of the required functionality seems to be working with the exception that when I jog on any axis they only go one direction. X only moves to the right. Y only moves the table away from me, Z only goes up towards the sky and I have no idea what Z is doing other than trying to nap.
On my diagnostics page the green light list illuminated for Digitize. The following three buttons are illuminated in yellow:
M1 Home
M2 Home
M3 Home
Does anyone have any idea what settings I need to change in order to get this working normally?
Thanks in advance,
Terry Wellman
Thanks,
Terry