Hi,
I'm new to the site and fairly new with mach3. I am building a plasma pipe cutter with a rotating chuck for the y axis. It is mainly used to cut hexagon holes in round tube. I think this might be something that might be caused by the way it's drawn in autocadd but my knowledge in autocadd is very limited. The Gcode is created and the torch moves down the x axis to cut but when it gets to the point of firing the torch an error comes up "Radius to end of arc is differs from radius to startof arc". That's one problem. The second is that the y axis (chuck) doesn't move. Even on programs with just straight lines the gcode shows it should be moving and the torch fire signal is on as it goes through the program but does not turn. I can turn it in manual mode so i know the motor works etc. Any help would be great! THX