Hello Guest it is March 29, 2024, 07:58:15 AM

Author Topic: Havering problems getting started with a Chinese made CNC 3040 machine  (Read 3903 times)

0 Members and 1 Guest are viewing this topic.

I am very new to the Mach 3 software as well with my machine. I purchased a CNC 3040 machine and I downloaded mach3 to run it as the manual suggested.  I followed the instructions in the manual to set up the ports and pins. I installed an after market parallel port in my PC. I found the address for this port and entered these addresses into the port setup and Axis selection.  At that point I was able to jog all the axis, not very smoothly but they did move.  I haven't changed any settings but now I can not get anything to jog. 

Like I said earlier I am a newby and I am probable missing something easy.  If anyHone. An help I would be greatly appreciated. 

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Todd, I'm sorry I missed this.  Have you made any progress?  You will probably get a lot more eyes on your post if you start a new one in the general discussion board.

Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!