I have just tried with the USB version and it is working as it should
Hood

I have also a problem with the index, encoder with Pokey 56E.
When i  "Enable the encoder", the counter seems to count ok.
But when i aslo activate "Enable reset on index" the count value is not correct, is not counting enough.
When i put the pokey input to ground, then the count value is reset.
I am reading the RAW values from the pokey config program. (so at the moment without Mach3)

This one is in the 'investigation' already.

The old plug-in not used? How now it is possible to show DRO-1000 on the screen?

The old plug-in not used? How now it is possible to show DRO-1000 on the screen?

What are you referring to? Give more details on what you would like to know.

I made a pendant:



using Pokeys. On old plugin i have drive LCD with macropump.
I saw that you have made new plugin, so i decide to upgrade Pokeys FW,
 and install new mach3 plugin. Than i encounter problems with writing to LCD.
I have set lcd plugin to secondary pins (28-34) because of previous pendant setup.
Now the buttons and MPG are working, but i dont get any content to LCD.
I have setup plugin like that:

Hi, Milan

We are working on supporting the LCD on PoKeys55. PoKeys56 series use a new buffered LCD mode, which is used in Mach3 plugin to improve speed.

Regards,
Matevž

Thank you Matevž.
Best regards,
Milan