General CNC Chat > Show"N"Tell ( What you have made with your CNC machine.)
complex turnings
marcel beaudry:
there are only two of them on photo they are hard to photograph the one shown is .625 on the side
Marcel
marcel beaudry:
if i have the permission i can put more photos of metal and wood ornamental turning.This ornametal turning has three .375 cubes on the same spindle with two rings
dfurlano:
You have my permission! LOL
Put the photos in the "Show "N" Tell" forum
marcel beaudry:
this one made in brass 1.250 square turned on allsides with rings on all branches with a smaller cube in the middle
marcel beaudry:
this one made in brass1.250 as hemisphere on the end of the branches are bigger than the hole in the first cube (.625hemisphere) hole in the first cube .500 smaller cube .375
Navigation
[0] Message Index
[#] Next page
Go to full version