Hello Guest it is March 28, 2024, 01:25:25 PM

Author Topic: steppers just quit moving mid motion but mach still running  (Read 2062 times)

0 Members and 1 Guest are viewing this topic.

steppers just quit moving mid motion but mach still running
« on: November 03, 2014, 10:42:04 PM »
havent changed any settings on this machine.  has ran relaiblly for a long time.  Today was running a job and all 3 axis just quit, and stopped where they were in the program.  In the mach screeen the program was still running.  Restarted everything and it ran fine for a little bit.  Did it again awhile later.  What would be the cause of this?  Any help would be appreciated.

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: steppers just quit moving mid motion but mach still running
« Reply #1 on: November 04, 2014, 11:52:24 AM »

Perhaps check your PSU output voltage when it all stops - the PSU may be going into thermal shutdown (or something similar).

Tweakie.
 
PEACE