Hello Guest it is March 28, 2024, 03:39:42 PM

Author Topic: Missing last line of G Code  (Read 2492 times)

0 Members and 1 Guest are viewing this topic.

Missing last line of G Code
« on: February 25, 2012, 05:06:31 PM »
Quite difficult to describe,  but I'll try......I'm running Mach3 v .022 with Calypso's MachStdMill screen set .

It's been running fine, although the machine is still being constructed.  Just noticed that the G Code is clipping the last line off.
In other words, the last line is missing.  However, if I 'Edit' the code, the last line is there!

I've shut down and rebooted, tried loading a different G Code file, tried another screen set but the issue is still there.

Any ideas?

Keith
« Last Edit: February 25, 2012, 05:12:14 PM by krsykes23 »

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Missing last line of G Code
« Reply #1 on: February 25, 2012, 05:21:14 PM »
You need to "End" the last line by pressing the enter key on the keyboard so that the cursor moves on to the next line. That is why it is good practice to put a % on the last line as it assures you have done so.
Hood
Re: Missing last line of G Code
« Reply #2 on: February 25, 2012, 05:25:52 PM »
Simple as that.  thanks Hood.

K