Hello Guest it is December 12, 2024, 12:58:39 PM

Author Topic: Motion abnormalities  (Read 3286 times)

0 Members and 1 Guest are viewing this topic.

Motion abnormalities
« on: February 05, 2012, 10:28:33 PM »
In the use mach3 control 4 axis engraving and milling machine, Yaskawa servo motor sports, motor frustrated phenomenon is what causes?

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
Re: Motion abnormalities
« Reply #1 on: February 06, 2012, 02:47:16 AM »
Not a clue what you are asking I am afraid, you will need to try and explain what your problem is.
Hood
Re: Motion abnormalities
« Reply #2 on: February 06, 2012, 02:56:51 AM »
MACH3 which set the maximum speed of the servo motor is 3000mm/min the acceleration 1500mm/ss finish roughing code, finishing code motor frustrated phenomenon, the movement is not smooth.
Re: Motion abnormalities
« Reply #3 on: February 06, 2012, 02:57:43 AM »
Not a clue what you are asking I am afraid, you will need to try and explain what your problem is.
Hood

MACH3 which set the maximum speed of the servo motor is 3000mm/min the acceleration 1500mm/ss finish roughing code, finishing code motor frustrated phenomenon, the movement is not smooth.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
Re: Motion abnormalities
« Reply #4 on: February 06, 2012, 04:47:13 AM »
Not much to go on and really still not sure what you are meaning but my guess would be that your issue may be the servo tuning in your drive.
Hood