Hello Guest it is March 28, 2024, 10:23:32 PM

Author Topic: Milling SolidWorks Model  (Read 9538 times)

0 Members and 1 Guest are viewing this topic.

Re: Milling SolidWorks Model
« Reply #20 on: February 05, 2012, 06:54:23 PM »
just did project in MeshCam (lets cut a sphere) loaded coede in Mach3 so far i see rough pass but no finishing is that normal? I will get my wax cut and will see what will be milled out but i think finishing was omited even though it was checked in MeshCam