I need some help. I have been trying to get my router table to run for some time now, embarrased about the actual time. I cannot seem to get my stepper motors to run smothly while in program at all. I also got stuck trying to get a 20 yo machine to run again. I have a new computer running Mach3 software with bran new stepper motors, breakout boards, and powersupplies.
The issue I am having is that my motors, no matter how I have them tuned, Fast, slow, or otherwise. will not run in program. They will slip, grind, or jump while in the middle of a movement. It is not a contant thing either. I have run a drilling program where everything was perfect for the first 200 or so holes, then BAM its off for one reason or another. How do I fix this issue.
I have 1.8°, 200 step, 7.8 amp motors, NEMA 32 with a driver set to 10 microsteps.
My steps per is approx 390 velocity 3048 and accelll about 250.
I use MM increments.
ANYHELP WILL DO, I AM AT MY WITS END WITH THIS THING!!!!!!!!