Hello Guest it is March 28, 2024, 04:38:07 PM

Author Topic: problem with a post processor  (Read 1897 times)

0 Members and 1 Guest are viewing this topic.

problem with a post processor
« on: December 10, 2011, 07:10:08 PM »
my Z is moving up so it will just cut air... attached is post processor file and I'm just pasting first lines of code

G00 G49 G40.1 G17 G80 G50 G90 G64
G20
(.25 Flat faced Center cutting 4 flute HSS)
M6 T1
M03 S2000
G01Z0.000
G01X-0.229Y0.541Z1.017 F60
X-0.185Y0.525Z1.010 F60
Y0.568Z1.003
X-0.449Z0.961
X-0.625
Y0.525
X-0.581Y0.541
X-0.537Y0.553
X-0.518Y0.558
X-0.493Y0.562
X-0.449Y0.567
X-0.361Y0.567
X-0.317Y0.562
X-0.293Y0.558
X-0.273Y0.553
Re: problem with a post processor
« Reply #1 on: December 10, 2011, 10:38:34 PM »
i think i have it figured out. post seems fine... drawing wasn't in a correct position... gave funny gcode results