Hi, guys, just got my machine to run finally, tried cutting the roadrunner for test, machine quits part way through program, always at same spot, is this because I am using demo version or a problem? Also what is your opinion on using the optimization settings, I have some pretty long and ugly lines when I run the driver test?
Thanks for any direction you can give.
Nooby

What line of code is it stopping on. The demo will run 1000 lines. The optimization is a good thing. I don't run anything other than the bare necessities on my mill PC.

Did you get your steps per sorted?

Brett

Run the file again and on the Mach 'Program' screen there is a line counter, is it stopping at 1000?

If so its the demo limit.

Graham.

Thanks for the comeback, I will try it again and see what line it quits on, I don't think it would be anywhere near 1000, I am still trying to grasp table settings etc. Yes I did enter the steps as you suggested Brett, that part seems to work fine.
Terry

Graham your absolutely right, it stopped on line 1000, thats amazing how many lines it went thru.
Thanks
Terry

I am new to this I have a ez-router and ran to the same thing when I first startred. I had to have my license to get past line 1000.

Max