Hello Guest it is March 29, 2024, 02:02:25 AM

Author Topic: Wacky axis movement  (Read 6035 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: Wacky axis movement
« Reply #10 on: November 06, 2011, 02:54:51 AM »
Don,

If your motor tuning is in mm (and it is correct) then just convert the metric entries to inch units (eg. 320 steps / 25.4 = 12.5984 steps) and so on for Vel. and Acc. - remember to save each axis settings before proceeding to next axis. Also make sure Config. / Select Native Units is set to inches. Then test it thoroughly and if necessary make any small adjustments to Vel. and Acc. to obtain the best, 100% reliable, performance.

Tweakie.
PEACE
Re: Wacky axis movement
« Reply #11 on: November 06, 2011, 09:04:08 AM »
Thanks Tweakie

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: Wacky axis movement
« Reply #12 on: November 06, 2011, 12:14:54 PM »
My pleasure sir  ;)

Tweakie.
PEACE