Hello Guest it is June 19, 2019, 11:48:43 AM

Author Topic: Drilling holes  (Read 2287 times)

0 Members and 1 Guest are viewing this topic.

Drilling holes
« on: December 20, 2006, 10:57:40 PM »
OK, I know this must be simple but it's escaping me.  I have a dxf with two layers.  One layer has a the toolpath and one has holes to be drilled.  How do I drill the holes?  I've drawn the holes both as point markers and as circles and can't find the key to getting LC to drill them.
I'm using LC 2.635.
« Last Edit: December 20, 2006, 10:59:18 PM by 01sporty »
Re: Drilling holes
« Reply #1 on: December 21, 2006, 08:51:59 AM »
If it is a point Lcam will drill them :)
Fixing problems one post at a time ;)

Re: Drilling holes
« Reply #2 on: January 09, 2007, 10:18:48 AM »
I have the same problem... :-[
But I have hole in the drawing....and if I transform it with "drill circle" botton the g code come out with  an error..
Must I sign hole with only center point in drawings?
Thanks  Ago
Take it easy.
Re: Drilling holes
« Reply #3 on: January 09, 2007, 05:04:33 PM »
I discover what's the problem..
I was working with z axis reversed and Lcam don't want negative numbers sometimes in some position..(or generate problems in some gcodes)
now I put z axis in right way ..adjust the negative numbers and everything work ;D
Sorry but I'm a beginner in this type of work..
Thanks again to all
« Last Edit: January 11, 2007, 05:34:52 PM by AGOMAGO »
Take it easy.