hello all

in some cnc software's, the acceleration data can be seen and modified. in mach3 we can see the same on config >> motor tuning.
is it possible to see the data which we save after setting the acceleration deceleration ramps?

regards

marker

XaccelValue = GetParameter(accelerationX)

(;-) TP

dear friend

i didn't get you.
can you just explain the same?
what my question is can we see the integer value of steps of acceleration value?

regrads

marker

GetParameter(accelerationX) gives you the MAX accel settings you applied in the config screen. They are always the same once set.

Mach will not exceed that value but it can use a lesser value to coordinate feedrates on moves.

IF you are asking if you have access to what MACH3 is actually using at any given time ? Then the answer is no for the normal access. BUT I do believe you can get that info from a plugin as the plugin interface has that data available.

(;-) TP