Hello Guest it is October 22, 2021, 03:26:16 PM

Author Topic: screwed up sign  (Read 5003 times)

0 Members and 1 Guest are viewing this topic.

Re: screwed up sign
« Reply #10 on: October 04, 2011, 07:19:24 PM »
For Rich and Dave:

Thanks for the suggestions,  LC is good enough to get me started.  I have made several small 8 inch by 12 inch signs and LC pocketed and did the islands perfectly.  This big sign used a different font and was much bigger, took two hours a 20 inches per minute....I,m going to try a different font and do it again.  great fun but a darn expensive and time consuming hobby...
Maybe Vcarve will have a sale this holiday season.. I'll wait and see...
Re: screwed up sign
« Reply #11 on: October 27, 2011, 09:10:35 AM »
Hi gumball
though new to this forum, I've suffered chronic CNC for some years

FWIW, I've just imported your DXF into VCP (4.6) and it ran flawlessly, both as a Vcarve and relief, no open vectors
if you're interested, give me a shout and I'll send you the gcode (not yet up to speed on posting files in this forum)

Regards, Lin
The wonder of a dancing  bear, is not how gracefully it dances...