Hello Guest it is March 28, 2024, 05:05:41 AM

Author Topic: Changing Demension  (Read 4374 times)

0 Members and 1 Guest are viewing this topic.

Offline BLA

*
  •  1 1
    • View Profile
Changing Demension
« on: June 06, 2011, 10:02:04 PM »
I am new to mach3 and using a licensed version and having a problem I can't figure out. I have a simple part program to run and the first time I loaded the code and ran it the part size was correct. When I moved my zero over the run it again the part comes out smaller, and each time afterward it will be the smaller size. This has happened a few times now and I can't figure out what I'm doing to cause this. Any ideas? Thanks in advance.