Hello Guest it is October 15, 2019, 06:03:40 PM

Author Topic: MACH 3 STOPS DURING WORK  (Read 1671 times)

0 Members and 1 Guest are viewing this topic.

MACH 3 STOPS DURING WORK
« on: August 18, 2011, 06:49:33 AM »
Hi everybody , what is the best procedure to do when  I during work (cuting) on my cnc router recieve message on my MACH scren that "the limit switch is trigerred"  , normaly the machine stops . But the machine not realy triggered limit switch , I think that is because some electric noise occur from time to time . Now my question is how to continues with work . I try simply to resset the warning on the screen and pusch the start button again . But that do not work very god . It is look like a some stepps missing between last stop position and new start ? What I can do ?
Thank for your help . ???   

Offline Hood

*
  •  25,855 25,855
  • Carnoustie, Scotland
    • View Profile
Re: MACH 3 STOPS DURING WORK
« Reply #1 on: August 18, 2011, 07:01:41 AM »
You  would need to rehome, scroll to the line you want to start from then use the Run From Here feature.
Hood

Offline Tweakie.CNC

*
  • *
  •  7,947 7,947
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: MACH 3 STOPS DURING WORK
« Reply #2 on: August 18, 2011, 07:55:29 AM »
To prevent future problems it may be a good idea to fit a 0.1uF capacitor between each switch input and GND on your Breakout Board. This trick seems to have cured the electrical noise problems of quite a few in the past.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.