Hello Guest it is May 23, 2019, 07:36:27 PM

Author Topic: Mach3 & bobcadcam  (Read 4596 times)

0 Members and 1 Guest are viewing this topic.

Re: Mach3 & bobcadcam
« Reply #10 on: July 31, 2011, 01:02:12 PM »
Dont think it will get you banned from here , the BobCAD forum possibly ;D

Well I'm not concerned about being banned from bobcad/cam forum...I'm not a member. I'm not going to pay for bobcad/cam without being able to use it just so I can join their forums.

Lol...that makes me wonder if the reason they wont let you join forum is simply because they want your money or they only want people that will praise their product on their forums? hmmm...possibly both?
Richard





[/quote]
Re: Mach3 & bobcadcam
« Reply #11 on: July 31, 2011, 01:06:43 PM »
yea, thanks for advice guys...think I will give dolphin a look see
Richard

Offline RICH

*
  • *
  •  7,331 7,331
    • View Profile
Re: Mach3 & bobcadcam
« Reply #12 on: August 01, 2011, 06:54:05 PM »
Sabastian,
Quote
I hope this doesn't get me banned from forum.

You expressed your experience as a new user of software with implied seeking of opinion. There is nothing wrong with that.
Should you have just vented angrily,ie; like you bought it and wanted to do harm to some company, then it would be looked upon differently and not tolerated.
The forum users here are above that, can accept honest factual criticism or evaluation of a product, since that is informative to the community of users.

BTW,
I remember spending hours trying out Ver 17 of it a few years back and gave up on it.

RICH