Mach Discussion > General Mach Discussion
Mach doing it again
BR549:
YOu would set the spindle on and off to 2 output pins. Then wire the pins to the VFD inputs that control on /off. Use a 3rd IF you require forward reverse.
(;-) TP
ranchak:
Can you elaborate a bit, I don't know which pins to use on the VFD. I thoink I may have found a way to wire this, but I would rather here your idea.
BR549:
(;-) You are going to have to look in the manual for the "VFD" to see what 2 pins they use to turn it on/off with. You will also probably have to program the VFD to do that function from an input. Most come setup to use the control panel.
Read the Manual (;-)
(;-) TP
Navigation
[0] Message Index
[*] Previous page
Go to full version