Hello Guest it is November 21, 2019, 11:50:08 PM

Author Topic: Strange problem with circles  (Read 1102 times)

0 Members and 1 Guest are viewing this topic.

Strange problem with circles
« on: January 26, 2016, 06:50:17 PM »
Hi,

I have been using mach3 for a while now originally on a home designed and built wood router, recently I upgraded and Brought an ooznest OX which I am really happy with. I do have a strange problem, I use Artcam Express for most of my path generation, if I produce a simple square inlay the parts fit perfect, if however I use curves the don't can anyone suggest where I should start looking, simulation shows the Artcam paths to be accurate, I can only assume it is a setting in Mach but not sure where to look.

Any ideas greatly received

Tony

Offline rcaffin

*
  •  1,003 1,003
    • View Profile
Re: Strange problem with circles
« Reply #1 on: January 27, 2016, 03:41:25 AM »
Read up about the difference between Incremental IJ mode and Absolute mode.
makes the circles look wrong. Very common problem.

Cheers
Roger