Hello Guest it is March 28, 2024, 07:14:52 AM

Author Topic: LCam and Rhino  (Read 2900 times)

0 Members and 1 Guest are viewing this topic.

LCam and Rhino
« on: January 17, 2007, 01:52:03 PM »
Hi to all,

I design a part in Rhino V 3.0 (in mm) and I imported in LCam. I generated the g-code. When I imported in Mach3 V R2.0.036 (setup is in mm also) my design is more larger than original design.
How can I fix that?

Another question - if I jog some place in my table and regen the toolpath:
How can I "tell" the DRO to start from that point?
The mil start to cut from a point which it is in g-code

N25 G90 G80 G40 G91.1
N30 G0  Z0.0000
N35  X19.8605  Y26.3802
N40  Z0.1000
N45 M3
N50 G1  Z0.0000  F1.00
N55  X35.3117   

Thank in advance
GB
 

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: LCam and Rhino
« Reply #1 on: January 17, 2007, 03:53:31 PM »
You can high lite your line of code that you want to start back on and click run from here. ;D It will ask for a prep move. Click yes. Try it out with some air cuts untill you get the hang of it.


Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!