Hello Guest it is March 28, 2024, 10:10:10 PM

Author Topic: Excello R8 Mill Cutter  (Read 2885 times)

0 Members and 1 Guest are viewing this topic.

Offline olf20

*
  •  325 325
    • View Profile
Excello R8 Mill Cutter
« on: May 21, 2011, 07:37:54 AM »
Just purchased this and trying to find what inserts this
uses.
Excello R8 Mill Cutter 1.9" 48mm base XLBN-200
Any information would be appreciated.
olf20 / Bob
Mach3, Atlas Knee Mill, 4th Axis, VcarvePro, ESS, Super PID.
Been Heating with corn since 1998

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Excello R8 Mill Cutter
« Reply #1 on: May 21, 2011, 10:55:38 AM »
Take a pic of the seats and post it and likely someone would be able to take a guess, also the measurements of the seat would be good.
Hood

Offline olf20

*
  •  325 325
    • View Profile
Re: Excello R8 Mill Cutter
« Reply #2 on: June 02, 2011, 07:51:14 PM »
Attached are some pictures of the face mill. I'm needing to know what type
of inserts to purchase for this.
olf20 / Bob
Mach3, Atlas Knee Mill, 4th Axis, VcarvePro, ESS, Super PID.
Been Heating with corn since 1998

Offline budman68

*
  • *
  •  2,352 2,352
    • View Profile
Re: Excello R8 Mill Cutter
« Reply #3 on: June 03, 2011, 05:06:06 AM »
Without any measurment references, I believe those are TPG322

Dave
----------------------------------------------------------------------
Just because I'm a Global Moderator, don't assume that I know anything !

Dave->    ;)

Offline olf20

*
  •  325 325
    • View Profile
Re: Excello R8 Mill Cutter
« Reply #4 on: June 03, 2011, 06:52:05 AM »
Thanks for the reply Dave!!
What measurements could I get to confirm?
Thanks again!!
olf20 / Bob
Mach3, Atlas Knee Mill, 4th Axis, VcarvePro, ESS, Super PID.
Been Heating with corn since 1998