Hello Guest it is April 20, 2024, 02:21:04 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Do step & direction wires need to be shielded cable?  (Read 2681 times)

0 Members and 1 Guest are viewing this topic.

Offline Jackal

*
  • 169 169
    • View Profile
Do step & direction wires need to be shielded cable?
« on: May 23, 2011, 05:15:42 PM »
 It's time for the step & direction wires from the B_O_B to the Geckos.

Do these need to be shielded cable?

If so, what gauge?

I have some of the shielded cable  left from the factory wiring. It's not very heavy gauge.

Thanks,
JAckal
Logged
Everything is bio-degradable if you run over it enough with a lawnmower.

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Do step & direction wires need to be shielded cable?
« Reply #1 on: May 23, 2011, 05:42:29 PM »
Dont need to be heavy, not sure of your USA gauges but just signal wiring is needed but definitely shielded in my opinion.
Hood
Logged

Offline Jackal

*
  • 169 169
    • View Profile
Re: Do step & direction wires need to be shielded cable?
« Reply #2 on: May 23, 2011, 05:44:11 PM »
Would encoder wire work?

JAckal
Logged
Everything is bio-degradable if you run over it enough with a lawnmower.

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Do step & direction wires need to be shielded cable?
« Reply #3 on: May 23, 2011, 06:20:30 PM »
Would be perfect, encoder signals and step/dir signals are basically the same thing :)
Hood
Logged
Pages: 1   Go Up
« previous next »