Hello Guest it is July 15, 2024, 07:50:05 PM

Author Topic: Mill orientation  (Read 10330 times)

0 Members and 1 Guest are viewing this topic.

Re: Mill orientation
« Reply #20 on: May 03, 2011, 05:20:36 AM »
Ok good I have all axis moving the right ways then. I will copy the XML when i get to the shop tonight.

Thanks again
Re: Mill orientation
« Reply #21 on: May 04, 2011, 09:00:42 PM »
I managed to get the mill oriented correctly tonight. In the input section. I had Home, ++ and -- all active for all 3 axis.

 as I only have switches on one end of the X & Y axis. I simply set the Home and X-- and Y++ inputs as active. this seems to have fixed the issue. when i would ref all home. i think it was getting confused. it seems to be working correctly now!