Third party software and hardware support forums. > Newfangled Solutions Mach3 Wizards

NEWFANGLED SOLUTIONS SOFTWARE - LATEST VERSION

(1/11) > >>

RICH:
This is the latest version of the software.

V2.86 fixes a bug where the material number was using the same DRO as the Xcenter value in the circular hole array wizard.

Ron Ginger:
Whenever I make a change to the NFS wizards I will place the new version here. It will be in the form of a zip file with the name Newfangled### where the ### will be the latest version number.

To install this you simply download the zip file, and un-zip it into your C:\Mach3\Addons folder.

The normal unzip will leave this with the ### Part. If you want to keep an old version around you can leave it this way, just select it from the wizard menu. More likely you will want to delete the old folder C:\Mach3\Addons\Newfangled then rename to the new one to remove the ###

JimV:
This version is vastly improved over the one I bought several years ago.  The threading now works... thanks!

One bug, however,  Threading does not seem to include feed speeds in the G-code?

I'm adding the feed speed to the G-code manually but it would be great if you could fix it sometime.

Thanks,

Jim Vogeley

Ron Ginger:
Thanks for the compliments on the improvements. I have tried to make it a better wizard.

You are right on the feed. I looked at the code quickly and see that in a couple of the conditions it adds a Feed to the first G01 move, but it never adds one to the G2 or G3.

Its going to be a problem to fix in a neat way, because all the G2 or 3 moves are inside a loop and if I add Feed it will be added to every G2 or G3 line. There  is nothing wrong with that, it just makes the code look ugly.

I am just finishing a major project in a set of Turn wizards. I'm sure after I release that I'll get a few bugs to track down. But I will get to the thread problem as soon as I can.

Arms Way:
I have a Tormach PCNC and a NewFangled license for v2.75... I down loaded the v2.86 file and copied it to my harddrive... C:\PCNC3\Addons\ ...folder. It came up as Newfangled286.  On the Mach3 screen built for Tormach.. I pulled down the Wizard Select and both Newfangled and Newfangled286 showed.  After picking Newfangled 286 the first page showed and when I clicked on 'Material Selection' there was no response...when I clicked on 'Help about materials' the dialogue box was blank... finally, pressing the 'Continue' button does nothing.  To exit the wiz I had to shut Mach3 down.

I would like to use Newfangled286 but I can't without some help......!!!

Thanks.. 

Navigation

[0] Message Index

[#] Next page