Hello Guest it is March 28, 2024, 02:04:23 PM

Author Topic: WCAM FastPath, Mach3 Post Processor  (Read 5653 times)

0 Members and 1 Guest are viewing this topic.

WCAM FastPath, Mach3 Post Processor
« on: April 20, 2011, 02:11:35 PM »
Anyone have a post processor for Waynemark Software WCAM FastPath to Mach 3 ? I've been using this program for 15+ years and hate to have to change. It's a CADCAM program written for the Servo Corp of California that's sold with their machines. Very user friendly but a little past it's prime.
Re: WCAM FastPath, Mach3 Post Processor
« Reply #1 on: September 29, 2011, 03:51:35 PM »
Contact Greg Brown at 626-395-7613, he wrote the WCam program and should be able to help you.  Good luck.