Update:
I got the MP-03 (peter holmans pendant kit based on the ModIO), working with the Smooth Stepper. Also, Greg of SS and I skyped each other this evening on some changes that may need to help this issue with out the below Dog-and-Pony show tricks to get them to play together.
Here is what I did to get them to work togther, I started by making sure ONLY MP-03 pendant plugin and NOT the SS plug in was enabled. I first varified that the MP-03 works as per normal.
Once it was working like it should I when into the Plugin config menu and disabled the MP-03.
Also, without my comp hooked to the machine, just using the MP-03 and SS by themselves......
I then made sure the ask about what motion thing to use was checked, so when i rebooted it would ask me if I wanted PP, or SS.....
On reboot, I rechecked and made sure that BOTH SS and MP-03 was disabled in the plugin config.
I then enabled ONLY the SS plugin, and closed and rebooted m3.
when it came up, I told it to use the SS, and once it came up, I made sure the SS was configured in PP as it should for the machine. NOTE!!!!!!!!: for testing, I set the Estop to Use active low (set the GREEN check), hit apply and ok, then hit the reset. Once the SS was configured and running as it should. I then CLOSED mach so that it would save the SS settings to the XML...
I then rebooted m3, when it came back up, it came back up in SS mode as it should.
Then I went to the configure plugins again, and enabled the MP-03, and double checked to make sure the Serial Plugin modbus was ON, and the Coms was working with NO errors, with the TEST dialog.
Then I closed M3 and rebooted again, both SS and MP-03 came up and played well together, with the ability to close and reopen m3 with no problems.......
I got with Greg and he is gonna do a NEW SS plugin also that will look at the XML and see if the MPG1 is enabled and the Ports and Pins for it are set to "0" ("0") is the setting that the MP-03 uses for MPG settings since it is pulled off the Modbus.
scott