Hello Guest it is March 28, 2024, 06:27:39 AM

Author Topic: Setting Feed Rate  (Read 2738 times)

0 Members and 1 Guest are viewing this topic.

Offline cdis

*
  •  11 11
    • View Profile
Setting Feed Rate
« on: April 06, 2011, 10:21:24 PM »
My feed rate is set at 1.00.  I try to change it to 75.00 but it will reset to 1.00.  I have tried to change it both on the "program run" and the "MDI"  Hope you can help.  SOrry for being such a novice.  Neil :P
Re: Setting Feed Rate
« Reply #1 on: April 06, 2011, 11:59:58 PM »
Is it possible the velocity is set to one in the motor tuning.

Is it the same for all axes.

Jeff

Offline ger21

*
  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: Setting Feed Rate
« Reply #2 on: April 07, 2011, 07:27:05 AM »
There's probably an F1 in your g-code.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline cdis

*
  •  11 11
    • View Profile
Re: Setting Feed Rate
« Reply #3 on: April 07, 2011, 08:34:05 PM »
I will check that

Thank you