Hello Guest it is April 16, 2024, 04:03:53 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Jog ok, g code steppers just screech  (Read 3250 times)

0 Members and 1 Guest are viewing this topic.

Offline DMF

*
  • 17 17
    • View Profile
Jog ok, g code steppers just screech
« on: March 28, 2011, 09:48:43 AM »
I set the steps per to 2000, feed rate at 12. Jog either with mouse or keyboard is ok. When I try MDI and g code the x and/or steppers just screech. It sounds like their trying to run too fast. What did I miss?
Logged

Offline Tweakie.CNC

*
  • *
  • 9,197 9,197
  • Super Kitty
    • View Profile
Re: Jog ok, g code steppers just screech
« Reply #1 on: March 28, 2011, 09:55:59 AM »
Hi and welcome to the forum.

Go back to motor tuning and reduce you velocity settings by about 20% to 30% below the point at which they stall and screech then save the setting before proceeding to the next axis etc.

Tweakie.
« Last Edit: March 28, 2011, 09:58:17 AM by Tweakie.CNC »
Logged
PEACE

Offline Overloaded

*
  • *
  • 4,921 4,921
    • View Profile
Re: Jog ok, g code steppers just screech
« Reply #2 on: March 28, 2011, 10:05:40 AM »
... also, when jogging to set the tuning, set  to 100% (pic) to jog full rapid speed, or hold down the SHIFT key while jogging.

Russ
Logged

Offline DMF

*
  • 17 17
    • View Profile
Re: Jog ok, g code steppers just screech
« Reply #3 on: March 28, 2011, 02:49:09 PM »
I was jogging at 100%, reducing the velocity fixed the issue. Thank you. :)
Logged
Pages: 1   Go Up
« previous next »