Hello Guest it is November 15, 2019, 02:11:14 AM

Author Topic: help please  (Read 4546 times)

0 Members and 1 Guest are viewing this topic.

Online Tweakie.CNC

*
  • *
  •  7,993 7,993
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: help please
« Reply #10 on: March 29, 2011, 03:50:09 AM »
Could be.
Look to see if 'Safe Z' under the config tab is enabled.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: help please
« Reply #11 on: March 30, 2011, 12:05:06 AM »
sorry is not z axis :-[ is Y axis 

Online Tweakie.CNC

*
  • *
  •  7,993 7,993
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: help please
« Reply #12 on: March 30, 2011, 02:25:01 AM »
OK, assuming you are getting to the last line of your GCode (M30) when it is run then my opinion is that the problem is within your controller rather than Mach or your setup. The M30 should terminate any pulses from Mach so what could be driving your Y axis ?

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.