Hello Guest it is March 29, 2024, 05:59:00 AM

Author Topic: Hesitation between Lines of G-code  (Read 12033 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Hesitation between Lines of G-code
« Reply #20 on: February 25, 2011, 08:50:52 PM »
Ok tried the code with your xml and I dont see any hesitation in the toolpath view or by watching the units per min DRO. Can you run the driver test and see what that is like.
The IJ mode is set with G90.1 or G91.1, the code you posted is Inc IJ mode so G91.1 would be inthe header.
Hood
Re: Hesitation between Lines of G-code
« Reply #21 on: February 26, 2011, 12:06:16 AM »
Hi Hood,

Thanks for checking that out. What's the driver test? Seems like I'm discovering new Mach features all the time...

Thanks for the G Code tip too. I'll change my header in my post and config.

Dan