Hello Guest it is September 15, 2025, 09:54:07 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: EMCO PC Mill and Turn 55 - Conversion  (Read 31562 times)

0 Members and 2 Guests are viewing this topic.

Offline kmckenn

*
  • 7 7
Re: EMCO PC Mill and Turn 55 - Conversion
« Reply #10 on: February 11, 2011, 04:52:09 PM »
@sblader: ... ya, doing a lot of "homework" on this topic, and am finally getting an understanding of the elements involved. THANK-YOU for the input!
Logged

Offline octopus80

*
  • 28 28
Re: EMCO PC Mill and Turn 55 - Conversion
« Reply #11 on: January 10, 2016, 07:19:03 AM »
Do somebody have the compleet electrical schematics of the Emco PC55 Mill so that I can convert it to Mach3 whit less modification.
Logged

Offline kennytent

*
  • 1 1
Re: EMCO PC Mill and Turn 55 - Conversion
« Reply #12 on: November 27, 2016, 07:33:11 PM »
 
Quote from: octopus80 on January 10, 2016, 07:19:03 AM
Do somebody have the compleet electrical schematics of the Emco PC55 Mill so that I can convert it to Mach3 whit less modification.

Did you ever convert your PC55 Mill?

I have a schematic.
Logged
Pages: « 1 2   Go Up
« previous next »