My suspecion is you have something else using or writing to those ULEDs....... something is stepping on your range......
I have a ADB and Relay boards x2 here, used to have all 10 but aurturo needed the other 8 back, it was working fine at that time, and I have not touched that code since.
So, that is what leads me to believe that something else is using that range, is the DSPMC using them? do you have some of them in a Brian or Macropump?
if you have checked your Config at the POKEYS software side, and your sure that the pk PLugin config matches your pksw config, and you dont see any thing else that might be trying to step on your ranges, then, get on Skype, and send me a contact request, in the request PUT WHAT THE REQUEST IS ABOUT!! if you dont, I will delete and block the request.
skype name: poppabear1000
we will then discuss a step by step walk through........ 90% of the time though these kind of issues are Configuration issues in pksw or plugin cfg, or something else is stepping on your range: usual culprits are Brains, Macropump (or other cyclic macro), other Plugins/devices that might be accessing/using that range. of ULEDs
NOTE: the Seq ON/OFF button on the ADB test page will INCREMENT the ULEDS one at a time (i.e. see your seq. counter UDRO2118 says 12), that may be interfering with it as well, type a "0" into that dro and hit enter, it will reset your counter to 0.
To test it you want to do this: hook up your ADB device, and with the counter at 0, push the seq ON?OFF button, your ULEDS on this page, and on your ADB hardware should turn on, ONE LED at a time starting in the upper right, and going left, then starts on next row, etc........ your external device should do the same and follow you as what your seeing on the test page.
scott