Hello Guest it is November 11, 2024, 02:01:14 AM

Author Topic: Step Morphing Question  (Read 2879 times)

0 Members and 1 Guest are viewing this topic.

Step Morphing Question
« on: January 01, 2011, 10:42:39 AM »
I just bought some 203V drives fro my new router.  After reading about it's micro to full step morphing, I wondered if a higher top speed could be achieved without the need to raise the kernel speed. 

I will be using 4032 steps per inch, and at a kernel speed of 45000.....I would top out at 669 IPM.  Would that increase using the 203v's ?
Re: Step Morphing Question
« Reply #1 on: January 01, 2011, 11:28:34 AM »
No, the step morphing is completely transparent to the CNC controller.

Regards,
Ray L.
Regards,
Ray L.
Re: Step Morphing Question
« Reply #2 on: January 01, 2011, 12:07:31 PM »
Thank you!