Hello Guest it is January 25, 2022, 04:04:53 PM

Author Topic: Milling parts from end of stock  (Read 10144 times)

0 Members and 1 Guest are viewing this topic.

Offline BR549

*
  •  6,952 6,952
    • View Profile
Re: Milling parts from end of stock
« Reply #30 on: January 01, 2011, 05:31:29 PM »
HHS for that app I would use 500 rpm and feedrate of 10 IMP doc .050" then set FRO to 50% adjust from there. Lots of coolant if a avaliable. Monitor chip load and chip color.  Even cuting with 1/4" bit not a problem IF your cut paramaters are correct.

(;-) TP